Prepare the module
Open the wireless controller and install its three supplied batteries. Connect the white harness to the module’s white socket and the black harness to its black socket.
Sources 1
Isolate and gain access
Disconnect the negative battery terminal with a 10 mm wrench. Remove the T25 screw beside the accelerator pedal and pull the console side panel down and away.
Sources 1
Mount and connect
Cable-tie the module to the console bracket in front of the heater core, leaving ample clearance from the heater core. Release the pedal connector’s red lock, then disconnect it. Join the module’s matching connector to the factory harness and its other connector to the pedal.
Sources 1
Secure the harness
Use the remaining ties to hold both cables out of the way. Reinstall the side panel and T25 screw, then reconnect the negative battery terminal. Follow the controller’s operating instructions separately for mode selection.
Sources 1
Products in this guide
Sources / references 1
- APR installation instructions ↗Reviewed Oct 8, 2026
Questions about this guide?
Share your vehicle details and what you have tried. Community posts are moderated; technical answers require verification.
Related discussions → · Ask a question →