Prepare the bore and carrier
Clean the arm bore with soap and Scotch-Brite, leaving it clean and dry. Apply a thin film of the supplied Loctite 609 around most of the carrier’s outer mating surface. Slide the carrier into the arm with a small turning motion until its shoulder is flush. Use the same orientation on both arms.
Sources 1
Retain the bearing
Fit the retaining cap with its lip facing the arm. Apply a small amount of the specified compound to the screws and tighten each to 95 inch-pounds. Seat the bearing spacers fully; the sheet allows a light tap for the snug fit.
Sources 1
Sources / references 1
- Dinan — manufacturer instructions ↗Reviewed Oct 8, 2026
Questions about this guide?
Share your vehicle details and what you have tried. Community posts are moderated; technical answers require verification.
Related discussions → · Ask a question →