Remove the original scoop
Remove its Torx securing screw and keep it for reassembly. Compress the accessible clip ends and lift the scoop out. Note the six attachment locations rather than levering blindly against the painted panel.
Sources 1
Prepare the carbon part
Check whether an M5 screw is preinstalled on the back of the replacement scoop. The GP3 document says to remove it before lowering the scoop. Confirm that all six clips are already installed on the carbon part.
Sources 1
Latch and verify
Lower the scoop into the openings. Press firmly at each of the six clip locations until engaged, then inspect from underneath to confirm engagement. Secure the scoop with the original Torx screw as directed by the final instruction. Do not consider the visible top surface alone proof that the clips have latched.
Sources 1
Sources / references 1
- Eventuri — manufacturer instructions ↗Reviewed Oct 8, 2026
Questions about this guide?
Share your vehicle details and what you have tried. Community posts are moderated; technical answers require verification.
Related discussions → · Ask a question →