Assemble both sides loosely
Safely support the car and remove both original links, holding a spinning stud with the 5mm key. Assemble the sway-bar joint with a washer under the bolt head, the link, another washer, then the bar, flat washer, lock washer and nut. Grease bushing faces that contact washers.
Sources 1
Align at ride height
Use the corresponding illustrated stack at the control-arm end. Snug the hardware, lower to normal ride height and check that each link is close to vertical. Use the supplied additional washers to correct lateral offset rather than forcing the bushings sideways.
Sources 1
Torque and maintain
After alignment, torque the upper joints and then lower joints to 35–40 ft-lb. Check noises and hardware after the test drive. Future lubrication must use the specified Energy Suspension grease on sleeves and bushing faces.
Sources 1
Products in this guide
Sources / references 2
- PERRIN official installation instructions ↗Reviewed Oct 8, 2026
- PERRIN official instructions database ↗Reviewed Oct 8, 2026
Questions about this guide?
Share your vehicle details and what you have tried. Community posts are moderated; technical answers require verification.
Related discussions → · Ask a question →