Prepare the mounting points
Remove the three indicated fasteners and separate their center pins. Return the lower shells to their original holes. Press the supplied fittings into them until they click, then rotate their rectangular tops to the orientation shown in the PDF.
Sources 1
Join and position the shroud
Assemble the two shroud pieces with the supplied M5 hardware, placing small washers beneath both bolt heads and nuts. Set the assembly on the car, align all three slots and press each fitting fully into its slot, starting at the left. Install the M6 screws with their larger washers.
Sources 1
Finish with a slow clearance check
Adjust the assembly as necessary and torque the three M6 mounting screws to 8 ft-lb. Slowly lower the hood to check clearance. Do not slam it during the first fit check; resolve any interference before closing normally.
Sources 1
Products in this guide
Sources / references 2
- PERRIN official installation instructions ↗Reviewed Oct 8, 2026
- PERRIN official instructions database ↗Reviewed Oct 8, 2026
Questions about this guide?
Share your vehicle details and what you have tried. Community posts are moderated; technical answers require verification.
Related discussions → · Ask a question →