Check and remove
Excludes 2013 LEV2 SULEV groups DTKXV02.0NC1 and DTKXV02.05NN. Ignition off; preserve settings/radio code and disconnect battery negative. Remove engine cover, unplug MAF and disconnect breather. Loosen throttle clamp, remove two scoop bolts and lift complete airbox from grommets. Retain parts.
Sources 1
Build shield
Cut trim into 12.5-inch and 28-inch lengths for shield opening and outer edge respectively. Transfer indicated factory grommet. Remove indicated battery-tray bolt, attach bracket 064313 with supplied hardware and mount shield on stud/bracket.
Sources 1
Build intake
Transfer MAF with supplied screws. Apply supplied glue to sleeve lip and insert sleeve. Fit vent elbow hand-tight plus two wrench turns. Clamp coupler 08440 to throttle; insert tube through shield and align before securing. Fit filter and clamp. Connect breather, trimming if needed. Refit engine cover and reconnect MAF.
Sources 1
Verify
Reconnect battery after checking fittings and clearance. Start in Park/Neutral with parking brake set. Correct leaks/noises before road testing. Periodically recheck alignment and fasteners. Use official drawings for hardware placement.
Sources 1
Products in this guide
Sources / references 1
- K&N 69-6033 official installation instructions ↗Reviewed Oct 8, 2026
Questions about this guide?
Share your vehicle details and what you have tried. Community posts are moderated; technical answers require verification.
Related discussions → · Ask a question →