Fit the filter and sealing plate
Slide the sealing plate onto the inlet tube. Push the filter fully onto the tube and secure its attached clamp. Insert the filter into the airbox, align the sealing-plate holes, and secure the plate with the supplied M5 screws and lock washers.
Sources 1
Transfer the temperature sensor
Install the sensor on the carbon tube using the supplied screws. Eventuri explicitly prohibits using the original sensor screws here. Do not substitute a visually similar fastener.
Sources 1
Ready for the installation stage
The completed bench assembly is ready for the vehicle-fitting sequence in the manufacturer document. Keep the airbox clean and consult its illustrated instructions for locating the two chassis mounts, wheel-arch scoop and original front duct. Bench assembly alone does not establish a finished installation.
Sources 1
Sources / references 1
- Eventuri — manufacturer instructions ↗Reviewed Oct 8, 2026
Questions about this guide?
Share your vehicle details and what you have tried. Community posts are moderated; technical answers require verification.
Related discussions → · Ask a question →