Transfer the sensor
Remove the two Torx screws retaining the original MAF sensor. Install the sensor into the new tube with the two supplied screws; do not reuse the original screws.
Sources 1
Set flow direction before tightening
Join the MAF tube to the filter housing with the silicone coupler and both clamps. Match the illustrated insertion and rotation relative to the Eventuri badge. Check the arrow on the sensor: the direction of airflow must be correct. Tighten the filter-housing clamp while leaving the tube-side clamp adjustable.
Sources 1
Complete alignment in the engine bay
With the duct and housing positioned according to the vehicle-fitting steps, align the rubber seal around the entire filter-housing perimeter. Only then secure the housing bracket. Reconnect the MAF plug fully, tighten the remaining clamps and secure the duct with its two M6 nuts. The bonnet protection strips and scoop fitting remain separate installation steps.
Sources 1
Sources / references 1
- Eventuri — manufacturer instructions ↗Reviewed Oct 8, 2026
Questions about this guide?
Share your vehicle details and what you have tried. Community posts are moderated; technical answers require verification.
Related discussions → · Ask a question →