Quick Reference

Eventuri G8X V2 intake: inlet and brace fastener reference

A focused reference with clear application limits, practical checks and manufacturer documentation.

PHTM PERFORMANCEPublished Oct 8, 2026Reviewed Oct 8, 2026Updated Oct 8, 2026

GUIDE OVERVIEW

Difficulty: Intermediate · 3/5
Time: Task time varies; read the procedure before starting
Vehicle / platform: EVE-G8XMV2-CF-INT or EVE-G8XMV2-CFM-INT on the G8X M3/M4 covered by the linked instructions.
Tools: Calibrated torque wrench
Angle-measuring tool

Turbo-inlet screws

The two right-side supplied M6 T30 inlet screws are specified at 15 Nm. Start their threads carefully before tightening. The left inlet’s lower screw is also specified at 15 Nm; retain the O-ring in its hole during installation. The upper left screw is described as tightened without a separate numeric value in the text.

Sources 1

Brace reassembly

At the final reassembly stage the document specifies top brace: 28 Nm; front brace nuts: 28 Nm; front brace screw: 56 Nm plus 90 degrees. Keep the named locations distinct and follow the illustrations.

Sources 1

Sources / references 1

Eventuri — manufacturer instructions ↗Reviewed Oct 8, 2026

Questions about this guide?

Share your vehicle details and what you have tried. Community posts are moderated; technical answers require verification.

KEEP READING